How are custom lingual appliances made?
Lingual orthodontics · · 2 min read
Digital planning of invisible braces, 3D printing of transfer jigs and custom wire bending.
The video is in Turkish and loads from YouTube when you press play.
In lingual orthodontics the brackets are bonded to the inner surface of the teeth, on the tongue side, so they cannot be seen from the outside. Behind this invisibility, however, lies a precise preparation process carried out separately for each patient. Because the inner surfaces of the teeth differ so much from one another, it is important that the bracket positions and the wires are planned individually for each patient.
1. Analysis: anatomy and bite
Each patient's tooth anatomy and bite dynamics are examined in detail. An intraoral digital scan, X-rays and photographs form the basis of this analysis. For details, see the article on orthodontic treatment planning.
2. Setting the goal digitally
Exactly where the teeth should be at the end of treatment is first planned on the computer. This digital setup is the reference for every step that follows: both the brackets and the wires are designed to this goal.
3. Positioning the brackets
Once the target alignment has been approved, the position of each bracket on the inner surface of the tooth is determined. The position of the bracket directly affects the direction of the force the wire will apply to the tooth, which is why it is one of the most critical steps in lingual treatment.
4. 3D-printed transfer jigs
So that the bracket positions set on the computer can be transferred exactly into the mouth, custom transfer jigs are produced with a 3D printer. These jigs carry the brackets to their planned positions and allow them to be bonded precisely. You can read about this stage in detail in my article on how lingual brackets are bonded to the teeth.
5. Custom wire bending
The bending geometry of the wires used in lingual treatment is also shaped to follow the same digital plan faithfully. This way, the wire guides the teeth towards the planned goal.
Invisible from the outside, but a precise process behind it
All the patient sees are small brackets bonded to the inner surface of the teeth and a thin wire. Yet this result depends on analysis, digital planning, production and clinical work all being carried out in harmony. The lingual orthodontic treatment I provide at my practice follows the same principle: the bracket positions are planned separately for each patient, and the transfer jigs and wires are prepared individually.
Frequently asked questions
Why does lingual treatment need custom preparation?
The inner surfaces of the teeth vary much more than the outer surfaces. When the bracket positions are planned for each patient's teeth and transferred with custom transfer jigs, and the wires are bent to the same plan, the planned movement is transferred to the teeth more accurately.
How long does it take to prepare the appliances?
Once the records have been taken, the planning, approval and production stages usually take a few weeks. The exact time depends on the details of the case.
