Skip to content
Appointments: +90 530 092 19 29

How is orthodontic treatment planned?

Orthodontics · · 2 min read

How is orthodontic treatment planned? (in Turkish)
The stages of orthodontic treatment planning and common questions about it.

The video is in Turkish and loads from YouTube when you press play.

The success of orthodontic treatment is decided at the planning stage, long before any brackets are bonded or the first aligner is fitted. A good plan looks at where the teeth will move, in what order and how far, together with the position of the jaws relative to each other and the appearance of the face.

1. The examination and talking about your expectations

Planning starts with listening to the patient. Is it crowded front teeth that bother you, gaps that show when you smile, or a problem with chewing and your bite? Then the teeth, gums, jaw joints and facial proportions are examined. Conditions that need attention before orthodontic treatment, such as gum health, cavities or old fillings, are also identified at this stage.

2. Taking records

A sound plan needs measurable data:

  • Intraoral digital scan: instead of traditional impressions, a 3D model of the teeth is obtained by scanning in a few minutes.
  • X-rays: a panoramic X-ray shows the teeth, their roots and any impacted teeth. A lateral cephalometric X-ray is used to assess the position of the jaws relative to each other and to the base of the skull.
  • Photographs: facial and intraoral photographs are used to analyse the smile and the profile.

3. Diagnosis: the real source of the problem

Crowding may look the same, yet its cause can differ: the teeth may be large for the jaw, the jaw may be narrow, or the upper and lower jaws may be positioned differently relative to each other. Cephalometric analysis and model measurements show whether the problem is dental or skeletal. The treatment method is chosen largely on the basis of this distinction.

4. The digital setup: seeing the goal in advance

Once the records have been evaluated, the teeth are moved one by one on the computer to create the target alignment. Thanks to this "digital setup":

  • The amount each tooth will move is measured,
  • How the space needed will be gained (expansion, minimal reshaping between the teeth, or rarely an extraction) is planned,
  • Custom appliances such as lingual wires or clear aligners are designed to this target.

At my practice I prepare custom lingual appliances and clear aligners from this digital plan.

5. Weighing up the options together

There is often more than one way to treat the same problem. The advantages, limitations and estimated duration of each option, lingual braces, clear aligners and traditional braces, are discussed. The decision is made together, based as much on your daily life and expectations as on the condition of your teeth.

6. The plan is updated throughout treatment

Tooth movement is a biological process; not every patient responds at the same speed. That is why progress is checked against the plan at follow-up appointments, and the plan is updated with interim scans if needed. A retention plan to protect the result after treatment is also considered from the very beginning.

Frequently asked questions

Is the treatment plan clear at the first examination?

At the first examination a general assessment is made and the possible options are discussed. The final plan is prepared after the scan, X-rays and photographs have been reviewed.

Is the result I see in the digital setup certain?

The digital setup shows the planned alignment of the teeth, but because tooth movement is a biological process, small corrections may be needed during treatment. The setup is a goal and a road map, not a promise.

Related articles